DIY Authenticator

Tools | DIY | DIY Authenticator...

Introduction

This function is use to lock the Maintain DIY Module so only Authorise person allow to access.

Requirement

• QR Reader
• Google Authenticator

DIY Authenticator

Setup

1. Enter account name or use default name. This will be shown in Google Authenticator list.

2. Enter a Access ID. This use by the system to pairing with the Google Authenticator.

3. Select the Device you wanted to use to Scan with.

4. Use the Google Authenticator to scan the QR barcode.
5. Enter the Code generated by the Google Authenticator.
6. Click Pair.

7. System will prompt below dialog if successfully pairing.

Each time user Click the Maintain DIY it will prompt below dialog for Verification Code.

Remove Locking

1. Click Tools | DIY | DIY Authenticator....
2. Enter the Verification Code.

3. System will prompt below option.
4. Click Remove Access ID.

Option Name	Properties
Remove Access ID	To permanent unlock the Maintain DIY
Recover Access ID	To retrieve the current Access ID
Reset Access ID	To recreate again new Access ID

5. System will prompt below dialog if successfully unlock

----------------------------------------------------------------------------------------------------------------------------------------------------

Make sure you had keep few copy of QRCode as once you lost all we not able to retrieve back the Access ID

----------------------------------------------------------------------------------------------------------------------------------------------------